Icord bangles { Tutorial }

I am on a diy jewelry kick. I love making these quick accessories that I can wear right away.

This is a simple bangle covered with a knitted icord using leftover fingering weight yarn.

You will need:

  • Leftover fingering/sock weight yarn (variegated yarn works great)
  • A thin bangle
  • Two dpn needles
  • A pair of pliers
  • A jump ring
  • A small charm
  • Darning needle and scissors

 

Cast on 4 stitches.

Slide your stitches on the dpn to the other side.

Place your bangle behind your stitches and bring your yarn from behind the bangle.

Knit the four stitches, making sure you pull the yarn tight from behind the bangle so your stitches are even.

Repeat until you have covered the entire bangle in icord

 

 

Sew both ends together and use the pliers to attach the charm to the jump ring and then attach to your bangle.

Enjoy your new bangle.

If you don't have a bangle, knit an icord to fit your wrist, attach charm, and a clasp.

Comments
  • Nicole October 21, 2013 at 10:28 am

    Sweet idea! Thanks :D!
    (Love the rings too!

  • Stephanie November 13, 2013 at 2:18 pm

    This is a fantastic tutorial! I just saved this page so I can make these as Christmas gifts!! you are amazing!

  • Post a comment

    Threaded commenting powered by interconnect/it code.